Çok Katmanlı Tuğla ve Kerpiç Malzemelerin Deneysel Değerlendirilmesi


Creative Commons License

Kıpçak F., Erdil B.

Adıyaman Üniversitesi Mühendislik Bilimleri Dergisi, cilt.12, sa.26, ss.266-280, 2025 (Hakemli Dergi)

Özet

Yığma yapı taşıyıcı sistemini oluşturan duvarlar oldukça narindir. Duvar yüksekliği arttıkça birim ve derz sayısı arttığı için narinlik artmaktadır. Tuğla ve kerpiç malzemesi ile yapılmış duvarlarda birimlerin küçük olması nedeniyle daha narin yapılar inşa edilmektedir. Birimlerin artışı duvar basınç dayanımını nasıl değiştirdiğine dair çalışma yeteri düzeyde bulunmamaktadır. Bu bağlamda çalışmada üst üste konulmuş tuğla ve kerpiç malzemelerinde yükseklik artışına bağlı olarak basınç değişimi araştırılmıştır. Tuğla birimleri arasında kireç karışımlı harç kullanılırken kerpiç birimleri arasında aynı özelliklere sahip kil, lif ve su karışımlı harç kullanılmıştır. Çalışmada tuğla, kerpiç ve harçların deneyleri yapılarak malzeme özellikleri belirlenmiştir. Duvar yüksekliği arttıkça basınç kapasitesinin önemli düzeyde düştüğü belirlenmiştir. Elde edilen verilere göre tuğla ve kerpiç malzemeleriyle üretilen duvarlar için duvar yüksekliğine bağlı olarak basınç kapasitesini tahmin etmek için denklem önerilmiştir. Önerilen denklem ve deney sonuçlarının tutarlı olduğu bulunmuştur.

The walls constituting the masonry structural system are quite fragile. As the wall height increases, the fragility increases as the number of units and joints increases. In walls made of brick and adobe material, more fragile structures are built due to the small number of units. There are not enough studies on how the increase in units changes the compressive strength of the wall. In this context, the study investigated the compression change in multi-layer brick and adobe materials due to the increase in height. Lime mixed mortar was used between the brick units while clay, fiber and water mixed mortar with the same properties was used between the adobe units. In the study, material properties of bricks, adobe and mortars were determined. It was determined that the compressive capacity decreased significantly as the wall height increased. According to the data obtained, an equation was proposed to predict the compressive capacity depending on the wall height for walls made of brick and adobe materials. The proposed equation and experimental results were found to be consistent.The walls constituting the masonry structural system are quite fragile. As the wall height increases, the fragility increases as the number of units and joints increases. In walls made of brick and adobe material, more fragile structures are built due to the small number of units. There are not enough studies on how the increase in units changes the compressive strength of the wall. In this context, the study investigated the compression change in multi-layer brick and adobe materials due to the increase in height. Lime mixed mortar was used between the brick units while clay, fiber and water mixed mortar with the same properties was used between the adobe units. In the study, material properties of bricks, adobe and mortars were determined. It was determined that the compressive capacity decreased significantly as the wall height increased. According to the data obtained, an equation was proposed to predict the compressive capacity depending on the wall height for walls made of brick and adobe materials. The proposed equation and experimental results were found to be consistent.