Evaluation of microstructure and mechanical behavior of Tip/AZ91 composites produced by hot press sintering
Materials Research Express, cilt.13, sa.21, 2026 (SCI-Expanded, Scopus)
- Yayın Türü: Makale / Tam Makale
- Cilt numarası: 13 Sayı: 21
- Basım Tarihi: 2026
- Doi Numarası: 10.1088/2053-1591/aebd4f
- Dergi Adı: Materials Research Express
- Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus, Chemical Abstracts Core, Compendex, INSPEC, Directory of Open Access Journals, Materials Science & Engineering Collection (ProQuest), Technology Collection (ProQuest)
- Anahtar Kelimeler: automotive materials, AZ91, composites, hot press sintering, Ti
- Açık Arşiv Koleksiyonu: AVESİS Açık Erişim Koleksiyonu
- Van Yüzüncü Yıl Üniversitesi Adresli: Evet
Özet
In the present study, the density, morphological characteristic and mechanical properties at both room and elevated temperatures of titanium microparticle-reinforced AZ91 matrix composites were evaluated. Density measurements of the specimens indicated a close agreement between the theoretical and experimental values. Porosity was determined to be below 1% in all specimens. Morphological analyses revealed that the titanium particles were located along the grain boundaries of the matrix alloy and exhibited a relatively uniform distribution. The field emission scanning electron microscopy, energy-dispersive x-ray spectroscopy, and x-ray diffraction analyses identified the presence of α-Mg, β-Mg17Al12, and Ti phases. No additional phases were detected beyond these. In this context, a pore-free microstructure devoid of secondary phases was obtained at the matrix–reinforcement interface. Compression tests revealed that both the yield and compressive strengths, as well as the ductility, were significantly improved compared to the monolithic alloy. At room temperature, the composites exhibited maximum values of 213.9 MPa for yield strength, 464.9 MPa for compressive strength, and 18.5% for ductility. These values show increases of approximately 18%, 90.5%, and 68%, respectively, compared to the monolithic alloy. Furthermore, a similar trend was observed at elevated temperatures, where the corresponding values remained significantly higher than those of the monolithic alloy. Due to their low density and superior mechanical properties at both room and elevated temperatures, composite specimens constitute a viable option for industrial applications, including the automotive sector.